The HomeLink® Universal Transceiver is designed to connect to your garage door opener, electric gate, home lighting, etc.

The Auto-Dimming Rearview Mirror is designed to help reduce glare coming from a vehicle’s headlights in the rear. HomeLink® with Auto-Dimming Rearview Mirror can connect to three electronic transmitters.

1. Press and release the HomeLink® Channel button , or , you would like to program. The HomeLink® User Interface Indicator will flash orange slowly (If it doesn’t, go to the steps of “Erasing HomeLink® Buttons” section on next page, and start over)
2. Position the garage-door opener remote 1-3 inches away from the HomeLink® buttons
3. While the HomeLink® User Interface Indicator is flashing orange, press and hold the garage-door opener remote button until the HomeLink® User Interface Indicator changes from orange to green
4. Wait until your garage door comes to a complete stop, regardless of position, before proceeding to the next step
   
5. Press and release the HomeLink® Channel button , or that you’re programming. If the HomeLink® User Interface Indicator is solid green, HomeLink® is connected and should operate when the HomeLink® Channel button , or is pressed. If your device operates, programming is complete
   — If the indicator light rapidly flashes green, firmly press, and hold the HomeLink® Channel button , or slowly, for two seconds up to three times in a row, to complete the programming process. Do not press the HomeLink® Channel button rapidly. If your device now operates, programming is complete
   — If the device does not operate, continue with step 6
6. At the garage door opener motor, (security gate motor, etc.) locate the “Learn”, “Smart”, “Set” or “Program” button. This can usually be found where the hanging antenna wire is attached to the motor-head unit (see the device’s manual to identify this button). The name and color of the button may vary by manufacturer. A ladder and/or second person may simplify the following steps
7. Firmly press and release the “Learn”, “Smart”, “Set” or “Program” button. You now have up to 30 seconds to complete the next step
8. Return to the vehicle and firmly press and hold the HomeLink® button slowly, for two seconds, up to three times in a row. Do not press the HomeLink® button rapidly. As soon as you see the garage door start to move, stop pressing any buttons until a few seconds after the garage door has come to a complete stop, regardless of position. At this point programming is complete and your device should operate when the HomeLink® Channel button is pressed

HomeLink® button

HomeLink® button

HomeLink® button

Garage Door Opener Status Indicator: Closing or Closed

HomeLink Operation Indicator

Garage Door Opener Status Indicator: Opening or Opened

HomeLink User Interface Indicator

Press and release the desired programmed HomeLink® Channel button , or . The HomeLink® User Interface Indicator should light green, solid or flashing, and your programmed device should operate. If your device does not operate, the HomeLink® programming was not successful, and you’ll need to reprogram the button(s).

1. Press and hold the desired HomeLink® Channel button , or you want to re-program. DO NOT release the button

2. The HomeLink® User Interface Indicator will illuminate solid green. Release the button as soon as the HomeLink® User Interface Indicator begins to flash orange, usually about 20 seconds

3. Proceed with the steps in the “Programming a New HomeLink® Button” section