HomeLink® with Auto-Dimming Rearview Mirror
The HomeLink® / Auto-Dimming Rearview Mirror* is designed to reduce glare from a vehicle’s headlights located in the rear and also connect up to three electronic transmitters into one location.
HomeLink® Channel 1
HomeLink® Channel 2
HomeLink® Channel 3
Garage Door Opener Status Indicator: Closing or Closed
HomeLink® Operation Indicator
Garage Door Opener Status Indicator: Opening or Open
HomeLink® User Interface Indicator
If programming for the first time, begin with Step 1 (repeating this step will delete all information).
To program non-rolling and rolling code garage door openers and other devices:
- Press and hold the left and buttons simultaneously until the indicator light begins to flash (to reprogram buttons, skip this step)
- Press and hold the desired button or and hold the button on the transmitter while it is approximately 1 to 3 inches away from the mirror. The HomeLink® Indicator light will flash rapidly once the frequency signal has been successfully programmed
- Locate the “learn” or “smart” button on the garage door’s motor head unit. Press and release the button and complete Step 4 within 30 seconds
- Firmly press and release the programmed HomeLink® button up to three times
Quick Tips:
- You can reprogram a single HomeLink® button by repeating Step 2
- Erasing the programmed buttons will delete all trained transmitters
Press one of the programmed HomeLink® buttons.
Press and hold the and buttons simultaneously for approximately 20 seconds, and then release both buttons within 30 seconds.
*See LEGAL page for legal information.
If your garage door opener was manufactured in 2011 or later, and you’re unable to program your vehicle’s HomeLink® system, you may need to purchase a HomeLink Repeater Kit.
For more information, go to www.HomeLink.com or call (800) 355-3515.
This feature may not be available on all Kia models. See section 4 in the Owner’s Manual for more information.
Button configuration may vary. Images are for illustrative purposes only and may not reflect actual feature or operation.
